Flexible 24V 64leds/m high efficiency 160lm/w 2835 LED Strips GL-FGP2835W64M08W24 with Ce/rohs certificate

1.SMD2835 high efficiency series, DC24V,64led/m,color temperature 6000K;

2.Indoor lighting IP20 and outdoor lighting IP67&IP68;

3.From 4.8w to 18w adjustable wattage;

4. With standard 3M self-stick , easy for installation;

5. CE Certificated and RoHS compliant;

6. Factory wholesale cost.OEM and ODM service.

Approvaled by standard ERP test, high efficiency led strips achieve as high as 160lm/w, which prove the B&C level energy efficiency rate. Glite GHC strips is environment-friendly and ideal light source for commerical lighting. There are varied choice from led density to wattage among the series.

2835 GHC series

·99.99% purity golden wire insde chips;

·Big size chip with high output lumen;

·Mitsubishi or Intermatix phosphor powder;

·Epistar or Sanan chip;

·100% purity copper Led lead frame

·35U copper PCB/double side PCB/back side soldering protection;

·300P genuine 3M tape/3M VHB tape;

·4 times QC checking( SMT+PCB JOINing+After aging testing+Wrestling test)

·Customized service available, customized MOQ>500M, 3 Years Warranty.

• Select DC2.8-2.9V, 27-29LM, SMD2835 chips, adopt DC24V and 8 LEDs/group solution to design 160LM/W led strips;

• 3OZ PCB,no voltage drop on 8 meters, accepted voltage drop on 10m.

• Lower watts at same brightness, better heat dissipation and better energy saving;

• Led with one BIN system, good color consistent;

• High luminous efficience can reach 160lm/w with RA>80&90;

• Longer lifespan with 5 years warranty;

Showcase lighting, window-dress, bathroom, advertisement, meeting room, etc.

·Never bend the LED strip more than R = 60 mm.

·Installation must not damage parts of the circuit board!LED strips are fine electronics and must be treated carefully.

·The LED strip is divided into sections with scissors symbol where it is possible to cut the LED strip. Cut LED strip of sharp scissors and always at 90°.

·When soldering the strip, the soldering temperature maximum of 300°C. Follow the polarity closely.

·1- When cutting the strip, use a shrink stocking. Remove 3M tape on the part to be "shrunk"

2-Place the shrink stocking over the LED strip.

3-Use a heat gun!

·Depending on the desired assembly, it may be necessary to point glue IP65 LED strips for permanent fastening. Remember that the substrate must be clean!

·All Glite Led Strips is dimmable by 0/1-10V,DALI,PWM,DMX controller.

·Connect Led 12v/24v to positive on driver, conenct Led - to negative on driver.

·LED must work under correct voltage,never work with incorrect driver voltages!

·Take the led strips from reels and open it before test the light with the driver!