24V 60leds/m RGB Digital WS2811 LED Strips GL-FBWS2811RGB60M10W24

1.WS2811 SMD5050 Digital LED Strip ,DC24V,60led/m,magic RGB digital,SDCM<5;

2.Indoor lighting IP20 and outdoor lighting IP65&IP67&IP68;

3.From 4.8w to 18w adjustable wattage;

4. With standard 3M self-stick , easy for installation;

5. CE Certificated and RoHS compliant;

6. Factory wholesale cost.OEM and ODM service.

WS2811 LED strip is an economic addressable led strip controlled by external IC WS2811. Each IC controls 6 LEDs hence every 6 LEDs are cuttable as one single pixel. Each pixel is individually addressable, this makes it very flexible in many applications.

GDC WS2811 Led Strip Features:

GDC WS2811 LED Strip Features:

· Output port compression 24V.

· Built in stabilivolt, Only add a resistance to IC VDD feet when under 24V power supply.

· Gray level 256 can be adjusted and scan frequency not less than 400Hz/s.

· Built in signal reshaping circuit,after wave reshaping to the next driver, ensure wave-form distortion not accumulate.

· Built-in electric reset circuit and power lost reset circuit.

· Cascading port transmission signal by single line.

· Any two point the distance more than 10m transmission signal without any increasecircuit.

· When the refresh rate is 30fps, low speedmodelc ascade number are not less than 512 points, high speed mode not less than1024 points.

· Send data at speeds of up to 400 Kbps and 800 Kbps two patterns.

· 2/3 OZ FPC, original high quality 3M 9495LE tape, special design strong packing. The LEDs are LM-80 tested and certified.

· Provide customized service, customized MOQ>500M, 3 years warranty.

1. The low-voltage DC24V power supply is used to drive the power supply, and the user is safer when using it.

2. The flexible FPC is used as the base material of the light strip, which has the characteristics of good electrical conductivity, fast heat dissipation, and bending resistance, and can be bent into various shapes at will.

3. It can be made into a variety of waterproof effects such as dripping waterproofing, wrapping waterproofing, and glue injection waterproofing in the silicone tube. make it usable in most places.

bars, commercial buildings, billboards, theme parks, LED screen,etc.

·Never bend the LED strip more than R = 60 mm.

·Installation must not damage parts of the circuit board!LED strips are fine electronics and must be treated carefully.

·The LED strip is divided into sections with scissors symbol where it is possible to cut the LED strip. Cut LED strip of sharp scissors and always at 90°.

·When soldering the strip, the soldering temperature maximum of 300°C. Follow the polarity closely.

·1- When cutting the strip, use a shrink stocking. Remove 3M tape on the part to be "shrunk"

2-Place the shrink stocking over the LED strip.

3-Use a heat gun!

·Depending on the desired assembly, it may be necessary to point glue IP65 LED strips for permanent fastening. Remember that the substrate must be clean!

·All Glite Led Strips is dimmable by 0/1-10V,DALI,PWM,DMX controller.

·Connect Led 12v/24v to positive on driver, conenct Led - to negative on driver.

·LED must work under correct voltage,never work with incorrect driver voltages!

·Take the led strips from reels and open it before test the light with the driver!

Fast Connectors: