12V 60leds/m RGB Digital WS2818 LED Strips GL-FBWS2818RGB60M10W12

1.WS2818 SMD5050 Digital LED Strip ,DC12V,60led/m,magic RGB digital,SDCM<5;

2.Indoor lighting IP20 and outdoor lighting IP65&IP67&IP68;

3.From 4.8w to 18w adjustable wattage;

4. With standard 3M self-stick , easy for installation;

5. CE Certificated and RoHS compliant;

6. Factory wholesale cost.OEM and ODM service.

WS2818 can continuous transmission function at breakpoints, no voltage drop at 12 volts, sufficient power input, can achieve chasing, flowing and other effects, good effect with most controllers on the market, high brightness , Energy saving, suitable for making advertising boards, party decorations, KTV, bars, etc.

GDC WS2818 Led Strip Features:

GDC WS2818 LED Strip Features:

· 12V/24V available, that work on different applications of stable pressure.

· Built-in voltage regulator tube, only add a resistance to IC VDD pin when the voltage is belowDC24V.

· Adopts the built-in signal reshaping circuit to achieve the signal waveform shaping, and thus no signal waveformdistortion takes place.

· Built-in power-on reset and brown-out reset circuits.

· The gray levels of each pixel of 256 levels, and the refresh frequency reaches to 2KHz/s.

· Serial cascading interface, data receiving and decoding are all achieved by one signal line.

· Signal Break-point Continuous Transmission, any pixel’s failure, it won’t affect the whole display effect.

· The distance of any two signal transmission points is less than 5 meters, there’s no extra circuits needed.

· When the refresh rate of 30fps, the cascade number are not less than 1024 pixels. l

· Send data at speeds of 800Kbps.

· 2/3 OZ FPC, original high quality 3M 9495LE tape, special design strong packing. The LEDs are LM-80 tested and certified.

· Provide customized service, customized MOQ>500M, 3 years warranty.

1. WS2818 is a 3-channel LED driver control circuit, its internal include intelligent digital port data latchandsignalreshaping amplification drive circuit.

2. Include a precision internal oscillator and a 12Vvoltage programmableconstant current control part, which achieves highly consistent color effect.

3. WS2818 has strong features in Signal Break-point Continuous Transmission, it adopts dual signal transmission,these signals are able to work together without interaction.

bars, commercial buildings, billboards, theme parks, LED screen,etc.

·Never bend the LED strip more than R = 60 mm.

·Installation must not damage parts of the circuit board!LED strips are fine electronics and must be treated carefully.

·The LED strip is divided into sections with scissors symbol where it is possible to cut the LED strip. Cut LED strip of sharp scissors and always at 90°.

·When soldering the strip, the soldering temperature maximum of 300°C. Follow the polarity closely.

·1- When cutting the strip, use a shrink stocking. Remove 3M tape on the part to be "shrunk"

2-Place the shrink stocking over the LED strip.

3-Use a heat gun!

·Depending on the desired assembly, it may be necessary to point glue IP65 LED strips for permanent fastening. Remember that the substrate must be clean!

·All Glite Led Strips is dimmable by 0/1-10V,DALI,PWM,DMX controller.

·Connect Led 12v/24v to positive on driver, conenct Led - to negative on driver.

·LED must work under correct voltage,never work with incorrect driver voltages!

·Take the led strips from reels and open it before test the light with the driver!

Fast Connectors: