12V 60leds/m RGB Digital DMX512 LED Strips GL-FBDMX512RGB60M10W12

Fast Connectors:

1.DMX512 SMD5050 Digital LED Strip ,DC12V,60led/m,magic RGB digital,SDCM<5;

2.Indoor lighting IP20 and outdoor lighting IP65&IP67&IP68;

3.From 4.8w to 18w adjustable wattage;

4. With standard 3M self-stick , easy for installation;

5. CE Certificated and RoHS compliant;

6. Factory wholesale cost.OEM and ODM service.

DMX512 RGB LED strip lights let you create millions of colors by just mixing red, green, and blue colors. With the ability to control each individual pixel and each individual channel, the color mix and color effects possibilities are endless.

GDC DMX512 LED Strip Features:

· This product is a full-color DMX512 external control soft light bar, every three lamp beads for a pixel point.Any one of the points is bad and does not affect the signal transmission, the points below the bad point normal use.

· Directly controlled by the controller of the DMX512 signal, receiving the console does not require decoding diagrams.

· Control of a single light running, flowing, open windows, meteor chasing, chasing, animation, video, text and other fancy changes. Any color can be displayed, any combination can be displayed, the easiest combination into any pattern especially made into a light bar screen to use.

· Any two-pixel transmission distance of 5 meters (the specific transmission distance to the site signal line and environmental interference varies).

·The signal is a serial single-wire cascade interface, through a signal line for transmission.

·PWM console can be adjusted to 256 gray levels, a total of 16777216 total luminescent colors can be adjusted.

·When the refresh rate of 30 frames/second, the high-speed mode cascade number does not exceed 512 points.

·2/3 OZ FPC, original high quality 3M 9495LE tape, special design strong packing. The LEDs are LM-80 tested and certified.

·Provide customized service, customized MOQ>500M, 3 years warranty.

1. Compatible with DMX512(1990) protocol.

2. Adopting RS485 signal trunk and signal differential transmission mode to ensure stronger ablility of anti-interference and longer transmission distance

3. Auto matically addressing with editor

4. Communication between DMX512 led digital strips are synchronized perfectly under support of Artnet / DMX512 led controllers.

bars, commercial buildings, billboards, theme parks, LED screen,etc.

·Never bend the LED strip more than R = 60 mm.

·Installation must not damage parts of the circuit board!LED strips are fine electronics and must be treated carefully.

·The LED strip is divided into sections with scissors symbol where it is possible to cut the LED strip. Cut LED strip of sharp scissors and always at 90°.

·When soldering the strip, the soldering temperature maximum of 300°C. Follow the polarity closely.

·1- When cutting the strip, use a shrink stocking. Remove 3M tape on the part to be "shrunk"

2-Place the shrink stocking over the LED strip.

3-Use a heat gun!

·Depending on the desired assembly, it may be necessary to point glue IP65 LED strips for permanent fastening. Remember that the substrate must be clean!

·All Glite Led Strips is dimmable by 0/1-10V,DALI,PWM,DMX controller.

·Connect Led 12v/24v to positive on driver, conenct Led - to negative on driver.

·LED must work under correct voltage,never work with incorrect driver voltages!

·Take the led strips from reels and open it before test the light with the driver!

Fast Connectors：